поиск модели
АРХИВ НОВОСТЕЙ
Ищете пресс-релиз, объявление или журнальную статью?
Вы найдете эти и другие материалы прямо здесь...
Дата публикации: 08 Февраля 2013
HF105 High-Frequency drivers… tested by Mr. Vance Dickason for Voice Coil This month, I will review three different drivers. I also received the new HF105 compression driver and the STH100 horn from FaitalPRO, an Italian Pro-Audio Speaker Manufacturer.

THE HF105 AND THE STH100
The last driver I examined this month was the FaitalPRO HF105 compression driver coupled with Faital's STH100 horn. I reviewed the FaitalPRO HF104 coupled to the same STH100 horn in Voice Coil March 2012.
The HF105 is essentially a ferrite-motor version (the HF104 uses neodymium), which in today's market means lower cost, but with only a modest increase in weight of 0.58 lb. Like the HF104, the HF105 is an interesting compression driver and has several unique features.
This includes a Ketone polymer annular-shaped diaphragm and a radial-shaped phase plug. The throat diameter is 25.4 mm (1") and it is coupled to a 28-mm (1.5") diameter voice coil wound on a Kapton former with CCAW.
Other features include an aluminum body, 40-W AES-rated power handling (80-W maximum), and solderable terminals.
The horn tested with the HF105 driver, as in the HF104 review, is Faital's 1" throat, 80-H x 70-V short elliptical tractrix flare STH100.
Testing commenced using the LinearX LMS analyzer to produce the 300-point stepped sine wave impedance plot.
With a 5.5-Ohm DCR, the HF105/STH100's minimum impedance was 5.9 Ohm and at 5.9 kHz.
For the next test sequence, I recess mounted the Faital HF105/STH100 in an enclosure with a 9" x 12" baffle and used a 100-point gated sine wave sweep to measure the horizontal and vertical on and off-axis at 2.83 V/1 m.
The SPL profile measures ±4 dB from 1 to 8.8 kHz. (The recommended cross-over frequency for the HF105 is a minimum of 1.7 kHz with a second-order network.)
Since the coverage of this horn is 80 H x 70 V, you wouldn't expect much of a difference in the horizontal and vertical off-axis plots.
For the remaining tests, I used the SoundCheck analyzer and 0.25" SCM microphone and power supply to measure distortion and generate time frequency plots. For the distortion measurement, the HF105/STH100 combination was mounted with the same baffle used for the frequency-response measurements.

I used a noise stimulus to set the SPL to 104 dB at 1 m (0.65 V) and measured the distortion with the microphone placed 10 cm from the horn's mouth. I then used SoundCheck to get a 2.83-V/1-m impulse response for this driver and imported the data into the SoundMap time/frequency software.
Comparing the HF104/STH100 data to the above data, the HF105/STH100's performance is similar to the neodymium version but at lower cost with not a lot more weight.

FaitalPRO officially thanks Mr. Vance Dickason for the kind permission to publish his tests.
WE ARE SORRY...
Unfortunately this article is not yet available in your language.
You will be redirected to the page you came from in a few seconds.
We appreciate your patience.